Cob: Frost-Protected Shallow Foundation
GlobalCirclenet
webmaster at globalcircle.net
Mon May 12 00:02:48 CDT 2003
That url doesn't come up for me. I get it at
http://oikos.com/catalog/detail.lasso?ID=7561&Order_ID=D8EADA250c79f34858tpK
Sk13E52&-token.affiliate=
paul tradingpost at gilanet.com
*********** REPLY SEPARATOR ***********
On 5/12/2003 at 1:35 PM D.J. Henman wrote:
>Lottvik,
> thanks for the Frost-Protected Shallow Foundation informatin.
>
>Darel
>
>----------------------
>
>~Lootvik~ wrote:
>
>> Only last January Mark Piepkorn wrote on this very list:
>>
>> ... the Frost-Protected Shallow Foundation method. HUD produced a
>> design guide for the system several years ago, in which it was
>> written, "An FPSF incorporates strategically placed insulation to
>> raise the frost depth around a building, thereby allowing foundation
>> depths as shallow as 16 inches, even in the most severe climates. The
>> most extensive use has been in the Nordic countries, where over one
>> million FPSF homes have been constructed successfully over the last 40
>> years. The FPSF is considered standard practice for residential
>> buildings in Scandinavia."
>> This design guide, which has quite a bit of good, thought-provoking,
>> and cross-applicable technical info, can either be purchased from
>> Oikos for 30 bucks:
>>
>http://oikos.com/catalog/Design_Guide_to_Frost_Protected_Shallow_Foundation
s.html
>>
>> or read for free here:
>> http://www.cs.arizona.edu/people/jcropper/desguide.html
>> Your choice.
>>
>>
>>
>>> Canada also has some good information about non-deep foundations,
>>> like used in Scandinavia, but I don't have the URL for it, or
>>> remember the proper foundation type name for this type. Anyone
>>> else out there?
>>>
>>> Cheers,
>>> Darel
>>>
>>> --------------------------
>>>
>>> puppetman at ix.netcom.com wrote:
>>>
>>>> The more I read about building construction the more I get
>>>> conflicting information.
>>>> In the building code of South Lyon (small city) Michigan,USA they
>>>> state that foundations should be a minimum of 48" deep. Unless the
>>>> building is less than 400sq ft. then it must only be 28" deep.
>>>
>>
>>
>>
>>