Rethink Your Life! Finance, health, lifestyle, environment, philosophy |
The Work of Art and The Art of Work Kiko Denzer on Art |
|
|
Cob: possible silly questionShannon C. Dealy dealy at deatech.comSun Dec 17 02:33:02 CST 2000
On Mon, 15 Dec 2014, nigella wrote: [snip] > I like the idea of earth based plaster and read that you could sieve the > same ingredients as you used for the cob and make plaster from it. It also > mentioned that seiving the straw is difficult. Here's my question (please > don't laugh :) > Providing you have electricity couldn't you just pick up a few yard sale > blenders and give the straw a whir? What even caused me to think of this is > my soapmaking. I grind the herbs to make soap why not grind straw? > nigella While you want short pieces of straw for your plasters (it has been quite awhile since I last did any plastering, but 1/4" - 1/2" straw comes to mind, anyone out there with more recent experience or a better memory?), I suspect you will have a great deal of difficulty getting any consistency using a blender. If you turn it on long enough to chop up the long pieces, I would expect that alot of your straw will have been turned to dust. The best approach I have seen so far is to run the straw through a chipper/shredder, and then run the output through a sieve to separate out the pieces that didn't get chopped up enough. The biggest problem with this approach is that the chipper/shredder generates large quantities of airborne dust, so dust masks are a necessity for anyone with breathing problems/allergies. It is also an approach that can only be used outside, so weather may be an issue, even if you are only planning on plastering indoors. Just in case any of your are crazy enough to consider doing this inside an incomplete building or shop area in the winter, consider that aside from the noise and breathing concerns, these quantities of dust in an enclosed space present a significant risk of spontaneous combustion/explosion. Shannon C. Dealy | DeaTech Research Inc. dealy at deatech.com | - Custom Software Development - | Embedded Systems, Real-time, Device Drivers Phone: (800) 467-5820 | Networking, Scientific & Engineering Applications or: (541) 451-5177 | www.deatech.com
|